The UT50 and UT51 are used to provide clocking signals when PSTN hardware is not available.

Compatible with Asterisk and CallWeaver

 FreeSWITCH support coming soon.

The B700 FlexBRI Hybrid Voice card provides both ISDN and analog connectivity for cost sensitive applications that require both.

This card comes standard with hardware echo cancellation, and uses the same module technology as the A200 and A500.

The A108 supports up to 240 voice calls or 32.8 Mbps of full-duplex data throughput over eight T1, E1, or J1 lines.

This card is A-Tick approved for use in Australia, and can be used for connecting up to eight OnRamp 10/20/30 connections.

The USBfxo provides FXO access to devices that do not contain PCI or PCI-express busses.

Powered by the USB bus, the device is fully supported by Asterisk and the Zaptel drivers.

The A500 base card accepts up to three A500 BRI modules. Each module provides two BRI ports, giving a total of six ports. Each module can be used as either TE or NT with no jumpers - simply invert the module

Up to three additional Remora^™ BRI daughterboards can be added to the base card, giving a maximum of 24 ports.

The A400 supports from 2 to 24 connections to analog telephone lines or handsets in a high density form factor

The base card holds from one to six modules, each of which can be FXO or FXS. Each module provides
connection for two analog lines. For additional capacity, one additional Remora cards can be added,
allowing a maximum of 24 ports (12 modules)

The A101 supports up to 2.048 Mbps of full duplex data through-put or up to 30 voice calls over a single T1, E1, or J1 line.

This card is A-Tick approved for use in Australia, and can be used for connecting to a single OnRamp 10/20/30

Covered by Sangoma's life time warranty on parts and labour (when registered), plus 30-day "no questions asked" return policy

The A200 supports from 2 to 24 connections to analog telephone lines or handsets.

The base card holds one or two modules, each of which can be FXO or FXS. Each module provides
connection for two analog lines. For additional capacity, up to 5 additional Remora cards can be added,
each holding an additional two modules.

This card is A-Tick approved for use in Australia (FXO connections only)

The A142 provides support for applications that need a speed synchronous connection,
such as X.25, datascope, SNA or broadcast satellite feed.

The card is available with PCI or PCI-express buss interface, and can be supplied
with X.21, V.35, RS23, or EIA530 cables

The A104 supports up to 120 voice calls or 8.192 Mbps of full-duplex data throughput over four T1, E1, or J1 lines.

This card is A-Tick approved for use in Australia, and can be used for connecting up to four OnRamp 10/20/30 connections

The A102 supports up to 60 voice calls or 4.096 Mbps of full-duplex data throughput over two T1, E1, or J1 lines.

This card is A-Tick approved for use in Australia, and can be used for connecting two OnRamp 10/20/30 connections